Alcatel-Lucent 7210 SAS M - Page 405

System Management
7210 SAS M, T, X, R6 Basic System Configuration Guide Page 405
Syntax [no] igmp-snooping
Context config>redundancy>multi-chassis>peer>sync
Description This command specifies whether IGMP snooping information should be synchronized with the multi-
chassis peer.
Default no igmp-snooping
port
Syntax port [port-id | lag-id] [sync-tag sync-tag]
no port [port-id | lag-id]
Context config>redundancy>multi-chassis>peer>sync
Description This command specifies the port to be synchronized with the multi-chassis peer and a
synchronization tag to be used while synchronizing this port with the multi-chassis peer.
Parameters port-id — Specifies the port to be synchronized with the multi-chassis peer.
lag-id — Specifies the LAG ID to be synchronized with the multi-chassis peer.
sync-tag sync-tag — Specifies a synchronization tag to be used while synchronizing this port with
the multi-chassis peer.
range
Syntax range encap-range sync-tag sync-tag
no range encap-range
Context config>redundancy>multi-chassis>peer>sync>port
Description This command configures a range of encapsulation values.
Parameters encap-range — Specifies a range of encapsulation values on a port to be synchronized with a multi-
chassis peer.
Values Dot1Q start-vlan-end-vlan
QinQ Q1.start-vlan-Q1.end-vlan
sync-tag sync-tag — Specifies a synchronization tag up to 32 characters in length to be used while
synchronizing this encapsulation value range with the multi-chassis peer.