Alcatel-Lucent 7210 SAS M Configuration Guide

LLDP Ethernet Port Commands
Page 418 7210 SAS M, T, X, R6 Basic System Configuration
Guide
notification
Syntax [no] notification
Context config>port>ethernet>lldp>dstmac
Description This command enables LLDP notifications.
The no form of the command disables LLDP notifications.
tx-mgmt-address
Syntax tx-mgmt-address [system]
no tx-mgmt-address
Context config>port>ethernet>lldp>dstmac
Description This command specifies which management address to transmit.
The no form of the command resets value to the default.
Default no tx-mgmt-address
Parameters system — Specifies to use the system IP address. Note that the system address will only be
transmitted once it has been configured if this parameter is specified
tx-tlvs
Syntax tx-tlvs [port-desc] [sys-name] [sys-desc] [sys-cap]
no tx-tlvs
Context config>port>ethernet>lldp>dstmac
Description This command specifies which LLDP TLVs to transmit.
The no form of the command resets the value to the default.
Default no tx-tlvs
Parameters port-desc — Indicates that the LLDP agent should transmit port description TLVs.
sys-name — Indicates that the LLDP agent should transmit system name TLVs.
sys-desc — Indicates that the LLDP agent should transmit system description TLVs.
sys-cap — Indicates that the LLDP agent should transmit system capabilities TLVs.

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English