System Management
7210 SAS M, T, X, R6 Basic System Configuration Guide Page 419
System Resource-Profile Commands
resource-profile
Syntax resource-profile policy-id [create]
no resource-profile policy-id
Context configure>system
Description This command enables the context to configure resource-profile parameters on the system.
Default no default
Parameters policy-id — Specifies a resource profile policy.
Values 1 — 16
create — Keyword used to create a resource profile instance.
g8032-fast-flood-enable
Syntax [no] g8032-fast-flood-enable
Context configure>system>resource-profile (in 7210 SAS-M)
configure>system>resource-profile>ingress-internal-tcam (in 7210 SAS-T)
Description. Platforms supported: 7210 SAS-M and 7210 SAS-T devices
This command is used to enable the G.8032 fast-flood feature.When this command is executed, it is
stored in the configuration file after admin save is executed. A system reboot is required for this
command to take effect.
It is recommended to enable this command to improve service failover time due to failures in the ring
path. When fast flood is enabled, on failure detection in one of the paths of the eth-ring, along with
MAC flush, the system starts to flood the traffic on-to the available path.
If this command is present in the configuration file, on reboot, the system allocates resources for
G.8032, by reducing the amount of resources available for use with ACLs. When this command is
used, G.8032 fastflood needs an entire chunk with “512” entries, therefore the amount of resources
available for use with ACLs is reduced by “512”. The user needs to free up resources used by ACLs
and make them available for use by G.8032, before enabling this command. The user should ensure
that the resource usage of ACLs has been appropriately modified before reboot, to make way for use
of this feature. The user can free up resources by either disabling the use of ACLs with a SAP or
deleting a SAP, so that an entire chunk of 512 entries is available.
Before enabling the g8032-fast-flood-enable command, the user must check if sufficient resources are
available. The tools>dump>system-resources command is available to check if sufficient resources
are available. The field 'Ingress Shared CAM Entries' shown in the output below tools>dump>system
resources command, must be more than or equal to 512 (free column in the output shown below).
To Next Page
Loading...
Need help?
General
