System Management
7210 SAS M, T, X, R6 Basic System Configuration Guide Page 461
Sample Output
A:pc-40>config>system>time>ntp# show system ntp
===============================================================================
NTP Status
===============================================================================
Enabled : Yes Stratum : 3
Admin Status : up Oper Status : up
Server enabled : No Server keyId : none
System Ref Id : 192.168.15.221 Auth Check : Yes
===============================================================================
A:pc-40>config>system>time>ntp# show system ntp all
===============================================================================
DROP — Lost peer in symmetric mode. Please wait while the associa-
tion is restarted.
RSTR — Access denied due to local policy. No further messages will
be sent to the server.
INIT — The association has not yet synchronized for the first time.
MCST — The association belongs to a manycast server.
NKEY — No key found. Either the key was never installed or is not
trusted.
RATE — Rate exceeded. The server has temporarily denied access
because the client exceeded the rate threshold.
RMOT — The association from a remote host running ntpdc has had
unauthorized attempted access.
STEP — A step change in system time has occurred, but the associa-
tion has not yet resynchronized.
System Codes
INIT — The system clock has not yet synchronized for the first time.
STEP — A step change in system time has occurred, but the system
clock has not yet resynchronized.
St
Stratum level of this node.
Auth
yes — Authentication is enabled.
no — Authentication is disabled.
Poll
Polling interval in seconds.
R
Yes — The NTP peer or server has been reached at least once in the
last 8 polls.
No — The NTP peer or server has not been reached at least once in
the last 8 polls.
Offset
The time between the local and remote UTC time, in milliseconds.
Label Description (Continued)
To Next Page
Loading...
Need help?
General
