Route Policy Command Reference
468 7705 SAR OS Router Configuration Guide
interface
Syntax interface interface-name
no interface
Context config>router>policy-options>policy-statement>entry>from
Description This command specifies the router interface, specified either by name or address, as a filter criterion.
The no form of the command removes the criterion from the configuration.
Default no interface
Parameters interface-name — the name of the interface used as a match criterion for this entry. If the string
contains special characters (#, $, spaces, etc.), the entire string must be enclosed within
double quotes.
level
Syntax level {1 | 2}
no level
Context config>router>policy-options>policy-statement>entry>from
config>router>policy-options>policy-statement>entry>to
Description This command specifies the IS-IS route level as a match criterion for the entry.
Default no level
Parameters 1 | 2 — matches the IS-IS route learned from level 1 or level 2
neighbor
Syntax neighbor {ip-address | prefix-list name}
no neighbor
Context config>router>policy-options>policy-statement>entry>from
config>router>policy-options>policy-statement>entry>to
Description This command specifies the neighbor address as found in the source address of the actual join and
prune message as a filter criterion. If no neighbor is specified, any neighbor is considered a match.
The no form of the command removes the neighbor IP match criterion from the configuration.
Default no neighbor
To Next Page
Loading...
