Alcatel-Lucent OmniSwitch AOS Release 7 - Page 170

Quick Steps for Configuring MC-LAG Configuring Multi-chassis Link Aggregation
page 8-6 OmniSwitch AOS Release 7 Network Configuration Guide March 2011
Status Standalone N/A
Hello Interval 1s 1s
IPC VLAN 4094 4094
5 Verify the link aggregate identifier ranges using the show linkagg range command as shown below:
OS10K [Chassis 1] -> show linkagg range
Operational Configured
Min Max Min Max
--------------------+--------+--------+-------------+-------+
Local 0 127 0 47
Peer N/A N/A 48 95
Multi-Chassis N/A N/A 96 127
OS10K [Chassis 2] -> show linkagg range
Operational Configured
Min Max Min Max
--------------------+--------+--------+-------------+-------+
Local 0 127 48 95
Peer N/A N/A 0 47
Multi-Chassis N/A N/A 96 127
6 Verify the virtual fabric link configuration and default VLAN settings using the show multi-chassis
vf-link command as shown below:
OS10K [Chassis 1] -> show multi-chassis vf-link
VFLink ID Oper Primary Port Config Port Active Port Def Vlan
-----------+----------+------------------+--------------+-------------+---------
0 Disabled N/A 0 0 1
OS10K [Chassis 2] -> show multi-chassis vf-link
VFLink ID Oper Primary Port Config Port Active Port Def Vlan
----------+----------+-------------------+--------------+-------------+---------
0 Disabled N/A 0 0 1
7 Verify the virtual fabric link configuration using the show multi-chassis vf-link member-port
command as shown below:
OS10K [Chassis 1] -> show multi-chassis vf-link member-port
VFLink ID Slot/Port Oper Is Primary
---------------+--------------+--------------+------------
0 1/1 Disabled No
0 1/17 Disabled No
0 3/1 Disabled No
0 3/17 Disabled No