Alcatel-Lucent OmniSwitch AOS Release 7 - Page 171

Configuring Multi-chassis Link Aggregation Quick Steps for Configuring MC-LAG
OmniSwitch AOS Release 7 Network Configuration Guide March 2011 page 8-7
OS10K [Chassis 2] -> show multi-chassis vf-link member-port
VFLink ID Slot/Port Oper Is Primary
---------------+--------------+--------------+------------
0 2/1 Disabled No
0 2/17 Disabled No
0 4/1 Disabled No
0 4/17 Disabled No
8 Verify the consistency of system-level mandatory parameters between the two chassis using the show
multi-chassis consistency command as shown below:
OS10K [Chassis 1] -> show multi-chassis consistency
Consistency Local Peer Status
-------------------------------+----------------+----------------+-------------
Chassis-ID N/A N/A NOK
Hello-Interval 1 N/A NOK
IPC-VLAN 4094 N/A NOK
STP-Path-Cost-Mode Auto N/A NOK
STP-Mode Per-VLAN N/A NOK
OS10K [Chassis 2] -> show multi-chassis consistency
Consistency Local Peer Status
-------------------------------+----------------+----------------+-------------
Chassis-ID N/A N/A NOK
Hello-Interval 1 N/A NOK
IPC-VLAN 4094 N/A NOK
STP-Path-Cost-Mode Auto N/A NOK
STP-Mode Per-VLAN N/A NOK
9 Save the configuration and reload using the write memory and reload commands as shown below:
-> write memory
-> reload from working no rollback-timeout
10 Once the system reboots verify the multi-chassis functionality using the commands shown below:
OS10K [Chassis 1] -> show multi-chassis vf-link member-port
VFLink ID Slot/Port Oper Is Primary
---------------+--------------+--------------+------------
0 1/1 Up Yes
0 1/17 Up No
0 3/1 Up No
0 3/17 Up No
OS10K [Chassis 2] -> show multi-chassis vf-link member-port
VFLink ID Slot/Port Oper Is Primary
---------------+--------------+--------------+------------
0 2/1 Up No
0 2/17 Up Yes
0 4/1 Up No
0 4/17 Up No