Publication 1762-UM001D-EN-P - March 2004
Installing Your Controller 2-17
1762 Expansion I/O
Dimensions
Mounting 1762
Expansion I/O
DIN Rail Mounting
The module can be mounted using the following DIN rails:
• 35 x 7.5 mm (EN 50 022 - 35 x 7.5), or
• 35 x 15 mm (EN 50 022 - 35 x 15).
Before mounting the module on a DIN rail, close the DIN rail latch.
Press the DIN rail mounting area of the module against the DIN rail.
The latch momentarily opens and locks into place.
Dimension Expansion I/O Module
A 90 mm (3.5 in.)
B 40 mm (1.57 in.)
C 87 mm (3.43 in.)
A
B
C
ATTENTION
During panel or DIN rail mounting of all devices, be
sure that all debris (metal chips, wire stands, etc.) is
kept from falling into the module. Debris that falls
into the module could cause damage when the
module is under power.
To Next Page
Loading...
