Publication 1762-UM001D-EN-P - March 2004
Communication Connections 4-3
Use the Communications Toggle Push Button to change from the
user-defined communication configuration to the default
communications mode and back on Channel 0. The parameters of the
Programmer/HMI Port are fixed at the default communications
configuration. The Default Communications (DCOMM) LED operates
to show when the controller is in the default communications mode
(settings shown on page 4-2).
TIP
The Communication Toggle Push Button must be
pressed and held for one second to activate.
The Communication Toggle Push Button only affects
the communication configuration of Channel 0.
COM
COM
0
1
0
1
Communications Toggle
Push Button
To Next Page
Loading...
