Allied Telesis AT-8000S Series Cli Reference Guide

Page 110
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
no ip igmp snooping mrouter-time-out
Parameters
•
time-out — Multicast device timeout in seconds (Range: 1 - 2147483647)
Default Configuration
The default value is 300 seconds.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the Multicast device timeout to 200 seconds.
ip igmp snooping leave-time-out
The ip igmp snooping leave-time-out Interface Configuration (VLAN) mode command configures the leave-
time-out. If an IGMP report for a Multicast group was not received for a leave-time-out period after an IGMP Leave
was received from a specific port, this port is deleted from the member list of that Multicast group. Use the no form
of this command to return to the default configuration.
Syntax
ip igmp snooping leave-time-out {time-out | immediate-leave}
no ip igmp snooping leave-time-out
Parameters
•
time-out — Specifies the leave-time-out in seconds for IGMP queries. (Range: 0-2147483647)
• immediate-leave — Indicates that the port should be immediately removed from the members list after
receiving IGMP Leave.
Default Configuration
The default leave-time-out configuration is 10 seconds.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
The leave timeout should be set greater than the maximum time that a host is allowed to respond to an IGMP
query.
Console(config)# interface vlan 2
Console(config-if)# ip igmp snooping mrouter-time-out 200

Allied Telesis AT-8000S Series Specifications

General

Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Humidity	5% to 95% non-condensing
Switching Capacity	104 Gbps
Forwarding Rate	77.4 Mpps
VLANs	4, 094
Layer 3 Features	Static routing, RIP v1/v2
Management	Web-based
Operating Humidity	10% to 90% non-condensing