Allied Telesis AT-8000S Series Cli Reference Guide

LACP Commands
Page 133
lacp timeout
The lacp timeout Interface Configuration (Ethernet) mode command assigns an administrative LACP timeout.
Use the no form of this command to return to the default configuration.
Syntax
lacp timeout {long | short}
no lacp timeout
Parameters
•
long — Specifies the long timeout value.
• short — Specifies the short timeout value.
Default Configuration
The default port timeout value is long.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example assigns a long administrative LACP timeout to Ethernet port 1/e6 .
Console(config)# interface ethernet 1/e6
Console(config-if)#
lacp timeout long

Allied Telesis AT-8000S Series Specifications

General

Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Humidity	5% to 95% non-condensing
Switching Capacity	104 Gbps
Forwarding Rate	77.4 Mpps
VLANs	4, 094
Layer 3 Features	Static routing, RIP v1/v2
Management	Web-based
Operating Humidity	10% to 90% non-condensing