Allied Telesis AT-8000S Series Cli Reference Guide

Page 292
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
User Guidelines
Use the crypto certificate generate Global Configuration mode command to generate an HTTPS certificate.
Specifying 0 as the port number effectively disables HTTP access to the device.
Example
The following example configures the http port number to 100.
ip http exec-timeout
The ip http port Global Configuration mode command specifies the TCP port to be used by the Web browser
interface. Use the no form of this command to return to the default configuration.
Syntax
ip http exec-timeout minutes [seconds]
no ip http exec-timeout
Parameters
•
minutes — Integer that specifies the number of minutes.
• seconds — Additional time intervals in seconds.
Default Configuration
The default is 10 minutes.
Command Mode
Global Configuration mode
User Guidelines
This command also configures the exec-timeout for HTTPS in case the HTTPS timeout was not set.
To specify no timeout, enter the ip https exec-timeout 0 0 command.
ip https server
The ip https server Global Configuration mode command enables configuring the device from a secured
browser. Use the no form of this command to return to the default configuration.
Syntax
ip https server
no ip https server
Default Configuration
Disabled.
Console(config)# ip http port 100

Allied Telesis AT-8000S Series Specifications

General

Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Humidity	5% to 95% non-condensing
Switching Capacity	104 Gbps
Forwarding Rate	77.4 Mpps
VLANs	4, 094
Layer 3 Features	Static routing, RIP v1/v2
Management	Web-based
Operating Humidity	10% to 90% non-condensing