Allied Telesis AT-8000S Series Cli Reference Guide

Web Server Commands
Page 291
Chapter 31.Web Server Commands
ip http server
The ip http server Global Configuration mode command enables configuring the device from a browser. Use the
no form of this command to disable this function.
Syntax
ip http server
no ip http server
Default Configuration
HTTP server is enabled.
Command Mode
Global Configuration mode
User Guidelines
Only a user with access level 15 can use the Web server.
Example
The following example enables configuring the device from a browser.
ip http port
The ip http port Global Configuration mode command specifies the TCP port to be used by the Web browser
interface. Use the no form of this command to return to the default configuration.
Syntax
ip http port port-number
no ip http port
Parameters
•
port-number — Port number for use by the HTTP server. (Range: 0 - 65535)
Default Configuration
The default port number is 80.
Command Mode
Global Configuration mode
Console(config)# ip http server

Allied Telesis AT-8000S Series Specifications

General

Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Humidity	5% to 95% non-condensing
Switching Capacity	104 Gbps
Forwarding Rate	77.4 Mpps
VLANs	4, 094
Layer 3 Features	Static routing, RIP v1/v2
Management	Web-based
Operating Humidity	10% to 90% non-condensing