Allied Telesis AT-8000S Series Cli Reference Guide

802.1x Commands
Page 303
Example
The following example enables 802.1X authentication on Ethernet port 1/e16.
dot1x re-authentication
The dot1x re-authentication Interface Configuration mode command enables periodic re-authentication of the
client. Use the no form of this command to return to the default configuration.
Syntax
dot1x re-authentication
no dot1x re-authentication
Default Configuration
Periodic re-authentication is disabled.
Command Mode
Interface Configuration (Ethernet)
User Guidelines
There are no user guidelines for this command.
Example
The following example enables periodic re-authentication of the client.
dot1x timeout re-authperiod
The dot1x timeout re-authperiod Interface Configuration mode command sets the number of seconds between
re-authentication attempts. Use the no form of this command to return to the default configuration.
Syntax
dot1x timeout re-authperiod seconds
no dot1x timeout re-authperiod
Parameters
•
seconds — Number of seconds between re-authentication attempts. (Range: 300 - 4294967295)
Default Configuration
Re-authentication period is 3600 seconds.
Console(config)# interface ethernet 1/e16
Console(config-if)# dot1x port-control auto
Console(config)#
interface ethernet 1/e16
Console(config-if)# dot1x re-authentication

Allied Telesis AT-8000S Series Specifications

General

Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Humidity	5% to 95% non-condensing
Switching Capacity	104 Gbps
Forwarding Rate	77.4 Mpps
VLANs	4, 094
Layer 3 Features	Static routing, RIP v1/v2
Management	Web-based
Operating Humidity	10% to 90% non-condensing