Allied Telesis AT-8000S Series Cli Reference Guide

Page 150
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
Chapter 19.Power over Ethernet Commands
Note
The PoE commands are operational in the AT-8000S/24, AT-8000S/24POE, AT-8000S/48 and AT-
8000S/48POE devices.
power inline
The port inline Interface Configuration (Ethernet) mode command configures the administrative mode of inline
power on an interface.
Syntax
power inline {auto | never}
Parameters
•
auto—Enables the device discovery protocol and, if found, supplies power to the device.
• never—Disables the device discovery protocol and stops supplying power to the device.
Default Configuration
The device discovery protocol is enabled.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example enables powered device discovery protocol on port 1/e1, so that power will be supplied to
a discovered device.
power inline powered-device
The power inline powered-device Interface Configuration (Ethernet) mode command adds a comment or
description of the powered device type to enable the user to remember what is attached to the interface. Use the
no form of this command to remove the description.
Syntax
power inline powered-device pd-type
Console(config)# interface ethernet 1/e1
Console(config-if)#
power inline auto

Allied Telesis AT-8000S Series Specifications

General

Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Humidity	5% to 95% non-condensing
Switching Capacity	104 Gbps
Forwarding Rate	77.4 Mpps
VLANs	4, 094
Layer 3 Features	Static routing, RIP v1/v2
Management	Web-based
Operating Humidity	10% to 90% non-condensing