Allied Telesis AT-8000S Series - Clear Ip Dhcp Snooping Database; Show Ip Dhcp Snooping Binding

Page 78
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
User Guidelines
After entering this command an entry is added to the DHCP snooping database. If DHCP snooping binding file
exists, the entry is added to that file also.
The entry is displayed in the show commands as a ‘DHCP Snooping entry’.
Example
The following example configures the DHCP snooping binding database and adds binding entries to the database.
clear ip dhcp snooping database
The clear ip dhcp snooping database Privileged EXEC mode command clears the DHCP binding database.
Syntax
clear ip dhcp snooping database
Parameters
This command has no arguments or keywords.
Default Configuration
No static binding exists
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example clears the DHCP binding database.
show ip dhcp snooping binding
The show ip dhcp snooping binding User EXEC mode command displays the DHCP snooping binding
database and configuration information for all interfaces on a switch.
Syntax
show ip dhcp snooping binding [mac-address mac-address] [ip-address ip-address] [vlan vlan] [ethernet
interface | port-channel port-channel-number]
Console# ip dhcp snooping binding 0060.704c.73ff 3 10.1.8.1 ethernet 1/e21
Console# clear ip dhcp snooping database