Allied Telesis AT-8000S Series Cli Reference Guide

Page 160
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
Syntax
wrr-queue cos-map queue-id cos1...cos8
no wrr-queue cos-map [queue-id]
Parameters
•
queue-id — Specifies the queue number to which the CoS values are mapped.
• cos1...cos8 — Specifies CoS values to be mapped to a specific queue. (Range: 0-7)
Default Configuration.
Command Mode
Global Configuration mode
User Guidelines
Queue 4 is reserved for stacking.
Example
The following example maps CoS 7 to queue 2.
qos wrr-queue threshold
The qos wrr-queue threshold Global Configuration mode command assigns tail-drop thresholds. Use no form of
this command to return to default values.
Syntax
qos wrr-queue threshold gigabitethernet queue-id threshold-percentage0 threshold-percentage1 threshold-
percentage2
no qos wrr-queue threshold gigabitethernet queue-id
Value (VPT) Queue
02
11
21
32
43
53
64
74
Console(config)# wrr-queue cos-map 2 7

Allied Telesis AT-8000S Series Specifications

General

Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Humidity	5% to 95% non-condensing
Switching Capacity	104 Gbps
Forwarding Rate	77.4 Mpps
VLANs	4, 094
Layer 3 Features	Static routing, RIP v1/v2
Management	Web-based
Operating Humidity	10% to 90% non-condensing