Allied Telesis AT-8000S Series Cli Reference Guide

System Management Commands
Page 263
Command Mode
User EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays system version information (only for demonstration purposes).
set system
The set system Priviledged EXEC mode command activates/deactivates features.
Syntax
set system qos {active | inactive} policy-based-vlans {active | inactive}
Parameters
•
qos active — Activate QoS.
• qos inactive — Deactivate QoS.
• policy-based-vlans active — Activate Policy based VLANs.
• policy-based-vlans inactive — Deactivate Policy based VLANs.
Default Configuration
This command has no default configuration.
Command Mode
Priviledged EXEC mode
User Guidelines
After executing the command, the startup-config is deleted and the device is rebooted. It is highly recommended
to backup the startup-config before executing this command.
Console> show version
Unit SW version Boot version HW version
---- ---------- ------------ ----------
1 v1.1.0.29 1.0.1.06 01.00.00
2 v1.1.0.29 1.0.1.06 01.00.00
3 v1.1.0.29 1.0.1.06 01.00.00
4 v1.1.0.29 1.0.1.06 01.00.00
5 v1.1.0.29 1.0.1.06 01.00.00
6 v1.1.0.29 1.0.1.06 01.00.00
console#

Allied Telesis AT-8000S Series Specifications

General

Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Humidity	5% to 95% non-condensing
Switching Capacity	104 Gbps
Forwarding Rate	77.4 Mpps
VLANs	4, 094
Layer 3 Features	Static routing, RIP v1/v2
Management	Web-based
Operating Humidity	10% to 90% non-condensing