Allied Telesis AT-8000S Series Cli Reference Guide

802.1x Commands
Page 307
Syntax
dot1x timeout supp-timeout seconds
no dot1x timeout supp-timeout
Parameters
•
seconds — Time in seconds that the device waits for a response to an EAP-request frame from the client
before resending the request. (Range: 1- 65535 seconds)
Default Configuration
Default timeout period is 30 seconds.
Command Mode
Interface configuration (Ethernet) mode
User Guidelines
The default value of this command should be changed only to adjust for unusual circumstances, such as
unreliable links or specific behavioral problems with certain clients. and authentication servers
Example
The following example sets the timeout period before retransmitting an EAP-request frame to the client to 3600
seconds.
dot1x timeout server-timeout
The dot1x timeout server-timeout Interface Configuration mode command sets the time that the device waits for
a response from the authentication server. Use the no form of this command to return to the default configuration.
Syntax
dot1x timeout server-timeout seconds
no dot1x timeout server-timeout
Parameters
•
seconds — Time in seconds that the device waits for a response from the authentication server.
(Range: 1-65535 seconds)
Default Configuration
The timeout period is 30 seconds.
Command Mode
Interface configuration (Ethernet) mode
Console(config-if) # dot1x timeout supp-timeout 3600

Allied Telesis AT-8000S Series Specifications

General

Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Humidity	5% to 95% non-condensing
Switching Capacity	104 Gbps
Forwarding Rate	77.4 Mpps
VLANs	4, 094
Layer 3 Features	Static routing, RIP v1/v2
Management	Web-based
Operating Humidity	10% to 90% non-condensing