Preface
Page 1
Preface
This guide describes how to configure an AT-8000S Series switch using the command line interface. The
commands are grouped by topic into the following chapters:
• Chapter 1. "Using the CLI" — Describe the CLI basic structure and command usage.
• Chapter 2. "ACL Commands" — Define MAC and IP based ACLs and ACL bindings.
• Chapter 3. "AAA Commands" — Define the authentication method lists for servers.
• Chapter 4. "Address Table Commands" — Register MAC-layer Multicast addresses, and handles MAC-
layer secure address to a routed port .
• Chapter 5. "Clock Commands" — Show the configuration or status of the Simple Network Time Protocol
(SNTP).
• Chapter 6. "Configuration and Image File Commands" — Display the contents of the currently running
configuration file, specify contents of image files.
• Chapter 7. "DHCP Option 82 Commands" — DHCP with Option 82 attaches authentication messages to
the packets sent from the host. DHCP passes the configuration information to hosts on a TCP/IP network.
This permits network administrators to limit address allocation authorized hosts.
• Chapter 8. "DHCP Snooping Commands" — Contains parameters for enabling DHCP Snooping on the
device
• Chapter 9. "Ethernet Configuration Commands" — Configure multiple Ethernet type interfaces.
• Chapter 10. "GVRP Commands" — Display the GARP VLAN Registration Protocol (GVRP) configuration
information, enable GVRP globally or on an interface.
• Chapter 11. "IGMP Snooping Commands" — Enable the Internet Group Management Protocol (IGMP)
snooping.
• Chapter 12. "IP Addressing Commands" — Define a default gateway, set an IP address for interface,
delete entries from the host.
• Chapter 13. "Line Commands" — Display line parameters, enable the command history function, or
configure the command history buffer size.— Configure system priority, physical port priority, assign
To Next Page
Loading...
