EasyManuals Logo

Allied Telesis AT-8000S Series Cli Reference Guide

Allied Telesis AT-8000S Series
334 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #306 background imageLoading...
Page #306 background image
Page 294
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface Users Guide
Parameters
minutes — Integer that specifies the number of minutes. (Range: 1 - 65535)
seconds — Additional time intervals in seconds. (Range: 0-59)
Default Configuration
The default configuration is the exec-timeout set by the ip http exec-timeout command.
Command Mode
Global Configuration mode
User Guidelines
To specify no timeout, enter the ip https exec-timeout 0 0 command.
Example
The following example configures sets the interval for the system to 1hour.
crypto certificate generate
The crypto certificate generate Global Configuration mode command generates a self-signed HTTPS
certificate.
Syntax
crypto certificate [number] generate [key-generate length][cn common- name][ou organization-unit][or
organization] [loc location] [st state] [cu country] [duration days]
Parameters
number — Specifies the certificate number. (Range: 1 - 2)
key-generate — Regenerate the SSL RSA key.
length — Specifies the SSL RSA key length. (Range: 512 - 2048)
common- name — Specifies the fully qualified URL or IP address of the device.
(Range: 1 - 64)
organization — Specifies the organization name. (Range: 1 - 64)
organization-unit — Specifies the organization-unit or department name.(Range: 1 - 64)
location — Specifies the location or city name. (Range: 1 - 64)
state — Specifies the state or province name. (Range: 1 - 64)
country — Specifies the country name. (Range: 2 - 2)
days — Specifies number of days certification is valid. (Range: 30 - 3650)
Default Configuration
The Certificate and SSL’s RSA key pairs do not exist.
If no certificate number is specified, the default certificate number is 1.
If no RSA key length is specified, the default length is 1024.
Console(config)#
ip https exec-timeout
60

Table of Contents

Other manuals for Allied Telesis AT-8000S Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allied Telesis AT-8000S Series and is the answer not in the manual?

Allied Telesis AT-8000S Series Specifications

General IconGeneral
Operating Temperature0°C to 40°C (32°F to 104°F)
Storage Humidity5% to 95% non-condensing
Switching Capacity104 Gbps
Forwarding Rate77.4 Mpps
VLANs4, 094
Layer 3 FeaturesStatic routing, RIP v1/v2
ManagementWeb-based
Operating Humidity10% to 90% non-condensing

Related product manuals