Allied Telesis AT-8000S Series Cli Reference Guide

Page 140
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
Parameters
•
console-only — Indicates that the device can be managed only from the console.
• name — Specifies the name of the Access List to be used. (Range: 1-32 characters)
Default Configuration
If no Access List is specified, an empty Access List is used.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures an Access List called mlist as the management Access List.
show management access-list
The show management access-list Privileged EXEC mode command displays management access-lists.
Syntax
show management access-list [name]
Parameters
•
name — Specifies the name of a management Access List. (Range: 1 - 32 characters)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the mlist management Access List.
Console(config)# management access-class mlist
Console#
show management access-list mlist
mlist
-----
permit ethernet 1/e1

Allied Telesis AT-8000S Series Specifications

General

Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Humidity	5% to 95% non-condensing
Switching Capacity	104 Gbps
Forwarding Rate	77.4 Mpps
VLANs	4, 094
Layer 3 Features	Static routing, RIP v1/v2
Management	Web-based
Operating Humidity	10% to 90% non-condensing