Allied Telesis AT-8000S Series Cli Reference Guide

SNMP Commands
Page 189
The show running-config Privileged EXEC mode command does not display the SNMP engine ID configuration.
To see the SNMP engine ID configuration, enter the snmp-server engineID local Global Configuration mode
command.
Example
The following example enables SNMPv3 on the device and sets the local engine ID of the device to the default
value.
snmp-server enable traps
The snmp-server enable traps Global Configuration mode command enables the device to send SNMP traps.
Use the no form of this command to disable SNMP traps.
Syntax
snmp-server enable traps
no snmp-server enable traps
Default Configuration
SNMP traps are enabled.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example enables SNMP traps.
snmp-server filter
The snmp-server filter Global Configuration mode command creates or updates a Simple Network Management
Protocol (SNMP) server filter entry. Use the no form of this command to remove the specified SNMP server filter
entry.
Syntax
snmp-server filter filter-name oid-tree {included | excluded}
no snmp-server filter filter-name [oid-tree]
Console(config) # snmp-server engineID local default
Console(config)# snmp-server enable traps

Allied Telesis AT-8000S Series Specifications

General

Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Humidity	5% to 95% non-condensing
Switching Capacity	104 Gbps
Forwarding Rate	77.4 Mpps
VLANs	4, 094
Layer 3 Features	Static routing, RIP v1/v2
Management	Web-based
Operating Humidity	10% to 90% non-condensing