Allied Telesis AT-8000S Series Cli Reference Guide

Spanning-Tree Commands
Page 215
Default Configuration
This command has no default configuration.
Command Mode
MST Configuration mode
User Guidelines
The pending MST region configuration takes effect only after entering the MST configuration mode.
Example
The following example displays a pending MST region configuration.
exit (mst)
The exit MST Configuration mode command exits the MST configuration mode and applies all configuration
changes.
Syntax
exit
Default Configuration
This command has no default configuration.
Command Mode
MST Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example exits the MST configuration mode and saves changes.
Console(config-mst)# show pending
Pending MST configuration
Name: Region1
Revision: 1
Instance Vlans Mapped State
-------- ------------ -------
0 1-9,21-4094 Enabled
1 10-20 Enabled
Console(config) #
spanning-tree mst configuration
Console(config-mst) # exit

Allied Telesis AT-8000S Series Specifications

General

Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Humidity	5% to 95% non-condensing
Switching Capacity	104 Gbps
Forwarding Rate	77.4 Mpps
VLANs	4, 094
Layer 3 Features	Static routing, RIP v1/v2
Management	Web-based
Operating Humidity	10% to 90% non-condensing