Allied Telesis AT-8000S Series Cli Reference Guide

QoS Commands
Page 163
Syntax
qos cos default-cos
no qos cos
Parameters
•
default-cos — Specifies the default CoS value of the port. (Range: 0 - 7)
Default Configuration
Default CoS value of a port is 0.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
If the port is trusted, the default CoS value of the port is used to assign a CoS value to all untagged packets
entering the port.
Example
The following example configures port 1/e15 default CoS value to 3.
show qos map
The show qos map User EXEC mode command displays all QoS maps.
Syntax
show qos map [dscp-queue]
Parameters
•
dscp-queue — Indicates the DSCP to queue map.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
There are no user guidelines for this command.
Console(config)# interface ethernet 1/e15
Console(config-if) qos cos 3

Allied Telesis AT-8000S Series Specifications

General

Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Humidity	5% to 95% non-condensing
Switching Capacity	104 Gbps
Forwarding Rate	77.4 Mpps
VLANs	4, 094
Layer 3 Features	Static routing, RIP v1/v2
Management	Web-based
Operating Humidity	10% to 90% non-condensing