Allied Telesis AT-8000S Series Cli Reference Guide

Page 56
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
Command Mode
Global Configuration mode
User Guidelines
The command is relevant for both received Unicast and Broadcast.
If there is at least 1 trusted key, then unauthenticated messages will be ignored.
Example
The following example authenticates key 8.
sntp client poll timer
The sntp client poll timer Global Configuration mode command sets the polling time for the Simple Network
Time Protocol (SNTP) client. Use the no form of this command to return to default configuration.
Syntax
sntp client poll timer seconds
no sntp client poll timer
Parameters
•
seconds — Polling interval in seconds (Range: 60-86400)
Default Configuration
Polling interval is 1024 seconds.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example sets the polling time for the Simple Network Time Protocol (SNTP) client to 120 seconds.
sntp broadcast client enable
The sntp broadcast client enable Global Configuration mode command enables Simple Network Time Protocol
(SNTP) Broadcast clients. Use the no form of this command to disable SNTP Broadcast clients.
Console(config)# sntp authentication-key 8 md5 ClkKey
Console(config)#
sntp trusted-key 8
Console(config)# sntp authenticate
Console(config)# sntp client poll timer 120

Allied Telesis AT-8000S Series Specifications

General

Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Humidity	5% to 95% non-condensing
Switching Capacity	104 Gbps
Forwarding Rate	77.4 Mpps
VLANs	4, 094
Layer 3 Features	Static routing, RIP v1/v2
Management	Web-based
Operating Humidity	10% to 90% non-condensing