Allied Telesis AT-8000S Series Cli Reference Guide

Page 156
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
Chapter 20.QoS Commands
qos
The qos Global Configuration mode command enables quality of service (QoS) on the device. Use the no form of
this command to disable QoS on the device.
Syntax
qos
no qos
Default Configuration
QoS is disabled on the device.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example enables QoS on the device.
show qos
The show qos User EXEC mode command displays quality of service (QoS) for the device.
Syntax
show qos
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
There are no user guidelines for this command.
Console(config)# qos

Allied Telesis AT-8000S Series Specifications

General

Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Humidity	5% to 95% non-condensing
Switching Capacity	104 Gbps
Forwarding Rate	77.4 Mpps
VLANs	4, 094
Layer 3 Features	Static routing, RIP v1/v2
Management	Web-based
Operating Humidity	10% to 90% non-condensing