Page 2
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
administrative LACP timeouts, display LACP information for Ethernet ports, and display LACP information for
a port-channel.
• Chapter 15. "Management ACL Commands" — Define a permit or deny a rule, or configure a management
access control list.
• Chapter 16. "PHY Diagnostics Commands" — Display the optical transceiver diagnostics.
• Chapter 17. "Port Channel Commands" — Enter the interface configuration mode to configure a specific,
or a multiple port-channel.
• Chapter 18. "Port Monitor Commands" — Start a port monitoring session, or display the port monitoring
status.
• Chapter 19. "Power over Ethernet Commands" — Configure and display Power over Ethernet device
settings.
• Chapter 20. "QoS Commands" — Enable Quality of Service (QoS) on the device, create policy maps, and
define traffic classifications
• Chapter 21. "Radius Commands" — Specify the source IP address used for communication with Remote
Authentication Dial-in User Service (RADIUS) servers, and display the RADIUS server settings.
• Chapter 22. "RMON Commands" — Display the Remote Network Monitoring (RMON) Ethernet history
statistics, alarms table and configuration.
• Chapter 23. "SNMP Commands" — Configure the community access string to permit access to the Simple
Network Management Protocol (SNMP) server, create or update SNMP server entries, and specify SNMP
engineID.
• Chapter 24. "Spanning-Tree Commands" — Configure the spanning-tree functionality.
• Chapter 25. "SSH Commands" — Display the Secure Socket Shell (SSH) public keys on the device, SSH
server configuration, or which SSH public key is manually configured.
• Chapter 26. "Syslog Commands" — Log messages to a syslog server, or limit log messages to a syslog
server.
• Chapter 27. "TACACS+ Commands" — Display configuration and statistical information about a Terminal
Access Controller Access Control System (TACACS+) server, or specify a TACACS+ host.
• Chapter 28. "System Management Commands" — Display and list system, version or Telnet session
information.
• Chapter 29. "User Interface Commands" — Display and list system, version or Telnet session information.
• Chapter 30. "VLAN Commands" — Enter the (Virtual Local Area Network) VLAN Configuration mode,
enable simultaneously configuring multiple VLANs, or adds or remove VLANs.
• Chapter 31. "Web Server Commands" — Enable configuring the device from a browser, or display the
HTTP server configuration.
• Chapter 32. "802.1x Commands" — Specify authentication, authorization and accounting (AAA) methods
for use on interfaces running IEEE 802.1x, and enable 802.1x globally.
Intended Audience
This guide is intended for network administrators familiar with IT concepts and terminology.
To Next Page
Loading...
Need help?
General
