Allied Telesis AT-8000S Series Cli Reference Guide

Page 118
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
Syntax
arp timeout seconds
no arp timeout
Parameters
•
seconds — Time (in seconds) that an entry remains in the ARP cache. (Range: 1-40000000)
Default Configuration
The default timeout is 60000 seconds.
Command Mode
Global Configuration mode
User Guidelines
It is recommended not to set the timeout value to less than 3600.
Example
The following example configures the ARP timeout to 12000 seconds.
clear arp-cache
The clear arp-cache Privileged EXEC mode command deletes all dynamic entries from the ARP cache.
Syntax
clear arp-cache
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example deletes all dynamic entries from the ARP cache.
Console(config)# arp timeout 12000
Console#
clear arp-cache

Allied Telesis AT-8000S Series Specifications

General

Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Humidity	5% to 95% non-condensing
Switching Capacity	104 Gbps
Forwarding Rate	77.4 Mpps
VLANs	4, 094
Layer 3 Features	Static routing, RIP v1/v2
Management	Web-based
Operating Humidity	10% to 90% non-condensing