Allied Telesis AT-8000S Series Cli Reference Guide

Page 134
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
show lacp ethernet
The show lacp ethernet Privileged EXEC mode command displays LACP information for Ethernet ports.
Syntax
show lacp ethernet interface [parameters | statistics | protocol-state]
Parameters
•
interface — Valid Ethernet port. (Full syntax: unit/port)
• parameters — Link aggregation parameter information.
• statistics — Link aggregation statistics information.
• protocol-state — Link aggregation protocol-state information.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example display LACP information for Ethernet port 1/e1.
Console show lacp ethernet 1/e1
Port 1/e1 LACP parameters:
Actor
system priority: 1
system mac addr: 00:00:12:34:56:78
port Admin key: 30
port Oper key: 30
port Oper number: 21
port Admin priority: 1
port Oper priority: 1
port Admin timeout: LONG
port Oper timeout: LONG
LACP Activity: ACTIVE
Aggregation: AGGREGATABLE
synchronization: FALSE
collecting: FALSE

Allied Telesis AT-8000S Series Specifications

General

Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Humidity	5% to 95% non-condensing
Switching Capacity	104 Gbps
Forwarding Rate	77.4 Mpps
VLANs	4, 094
Layer 3 Features	Static routing, RIP v1/v2
Management	Web-based
Operating Humidity	10% to 90% non-condensing