Allied Telesis AT-8000S Series Cli Reference Guide

Page 310
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
show dot1x users
The show dot1x users Privileged EXEC mode command displays active 802.1X authenticated users for the
device.
Syntax
show dot1x users [username username]
Parameters
•
username — Supplicant username (Range: 1-160 characters)
Default Configuration
This command has no default configuration.
Reauth Period Reauthentication period.
Username The username representing the identity of the Supplicant. This field shows the
username in case the port control is auto. If the port is Authorized, it shows the
username of the current user. If the port is unauthorized it shows the last user
that was authenticated successfully.
Quiet period The number of seconds that the device remains in the quiet state following a
failed authentication exchange (for example, the client provided an invalid
password).
Tx period The number of seconds that the device waits for a response to an Extensible
Authentication Protocol (EAP)-request/identity frame from the client before
resending the request.
Max req The maximum number of times that the device sends an Extensible
Authentication Protocol (EAP)-request frame (assuming that no response is
received) to the client before restarting the authentication process.
Supplicant timeout Time in seconds the switch waits for a response to an EAP-request frame from
the client before resending the request.
Server timeout Time in seconds the switch waits for a response from the authentication server
before resending the request.
Session Time The amount of time the user is logged in.
MAC address The supplicant MAC address.
Authentication Method The authentication method used to establish the session.
Termination Cause The reason for the session termination.
State The current value of the Authenticator PAE state machine and of the Backend
state machine.
Authentication success The number of times the state machine received a Success message from the
Authentication Server.
Authentication fails The number of times the state machine received a Failure message from the
Authentication Server.

Allied Telesis AT-8000S Series Specifications

General

Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Humidity	5% to 95% non-condensing
Switching Capacity	104 Gbps
Forwarding Rate	77.4 Mpps
VLANs	4, 094
Layer 3 Features	Static routing, RIP v1/v2
Management	Web-based
Operating Humidity	10% to 90% non-condensing