Page 18
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
no mac access-list access-list-name
Parameters
•
access-list-name — Name of the MAC-Access List.
Default Configuration
No MAC-Access List is defined.
Command Mode
Global Configuration mode
User Guidelines
MAC ACLs are defined by a unique name. An IPv4 ACL, IPv6 ACL and MAC ACL cannot share the same name.
Example
The following example shows how to create a MAC ACL.
permit (MAC)
The permit MAC-Access List Configuration mode command sets permit conditions for a MAC-Access List.
Syntax
permit {any | {source source-wildcard} any | {destination destination-wildcard}} [vlan vlan-id] [cos cos cos-
wildcard] [ethtype eth-type]
Parameters
•
source — Source MAC address of the packet.
• source-wildcard — Wildcard bits to be applied to the source MAC address. Use 1s in the bit position to be
ignored.
• destination — Destination MAC address of the packet.
• destination-wildcard — Specifies wildcard bits to be applied to the destination MAC address. Use 1s in bit
positions to be ignored.
• vlan-id — Specifies the ID of the packet VLAN. (Range: 0-4095)
• cos — Specifies the Class of Service (CoS) for the packet. (Range: 0-7)
• cos-wildcard — Specifies wildcard bits to be applied to the CoS.
• eth-type — Specifies the Ethernet type in hexadecimal format of the packet.
Default Configuration
No MAC ACL is defined.
Command Mode
MAC-Access List Configuration mode
Console(config)#
mac access-list
macl-acl1
Console(config-mac-al)#
To Next Page
Loading...
