Allison B 400 - Page 252

Copyright © 1998 General Motors Corp. E–15
WTEC II ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL
APPENDIX E — CONNECTOR PART NUMBERS, TERMINAL PART
NUMBERS, TOOL PART NUMBERS, AND REPAIR INSTRUCTIONS
1–4. PACKARD METRI-PACK 280 SERIES CONNECTORS — PULL-TO-SEAT (8-WAY
FREIGHTLINER; 5-WAY NAVISTAR CAB HARNESS; 2-WAY NAVISTAR AND FORD
CAB HARNESS; INTERNAL HARNESS SOLENOID AND C3 PRESSURE SWITCH)
A. Connector/Terminal Repairs
NOTE: Crimping anvils will be listed following the terminal part numbers for the various connectors in this
section. The anvil for the core crimp is always listed first.
Crimping Tool J 38125-7
Remover Tool J 38125-13
Use Description P/N
8-Way Freightliner VIM 8-Pin Plug
Terminal (Pin)
(Use crimping anvils “C” and “A”)
Secondary Lock
8-Pin Receptacle
Terminal (Socket)
(Use crimping anvils “2” and “A”)
Secondary Lock
12066195
12034047
12065141
12064998
12034046
12064999
5-Way Navistar Cab Harness 5-Pin Plug
Terminal (Socket)
(Use crimping anvils “2” and “5”)
Connector Seal
Secondary Lock
Wire Seal
12084891
12077411
15300023
15300017
12015323
2-Way Navistar Cab Harness 2-Pin Receptacle
Terminal (Pin)
(Use crimping anvils “C” and “5”)
Secondary Lock
Wire Seal
15300002
12040559
15300014
12015360
2-Way Ford Cab Harness 2-Pin Plug
Connector Seal
Wire Seal
Terminal (Socket–12 gauge wire)
(Use crimping anvils “F” and “F”)
Terminal (Socket–18 gauge wire)
(Use crimping anvils “2” and “A”)
12033769
12077383
12040972
12033997
12020156
Solenoid/C3 Pressure Switch
(Switch)
Connector
C3 Pressure Switch (Harness) Connector
Solenoid/C3 Pressure Switch
(Switch)
Terminal
(Use crimping anvils “C” and “D”)
C3 Pressure Switch (Harness) Terminal
(Use crimping anvils “C” and “D”)
Solenoid (A, B, and G) Terminal (2 Wire) B
(Use crimping anvils “A” and “B”)