WTEC II ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL
E–20 Copyright © 1998 General Motors Corp.
APPENDIX E — CONNECTOR PART NUMBERS, TERMINAL PART
NUMBERS, TOOL PART NUMBERS, AND REPAIR INSTRUCTIONS
C. Terminal Crimping
(cont’d)
10. Tug on terminal and assure the crimp is tight.
11. Insert terminal into connector with the lock tab toward the center line of the connector
(Figure E–5, View C).
12. The terminal should “click” into place and you should not be able to pull the terminal out by hand.
13. Reinstall the secondary lock.
To Next Page
Loading...