Allison B 400 - Page 260

Copyright © 1998 General Motors Corp. E–23
WTEC II ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL
APPENDIX E — CONNECTOR PART NUMBERS, TERMINAL PART
NUMBERS, TOOL PART NUMBERS, AND REPAIR INSTRUCTIONS
1–6. PACKARD WEATHER PACK CONNECTORS (TPS; 3-WAY RMR SENSOR;
HD RETARDER TEMPERATURE; 6-WAY GILLIG VIM; 4-WAY RMR DEVICE,
TYPE 3; 3-WAY RMR DEVICE (DEDICATED PEDAL))
A. Connector/Terminal Repairs
B. Terminal Removal
1. Unlatch and open the secondary lock on the connector (Figure E–4, View A).
2. On the front of the connector, insert remover tool J 38125-10 over the terminal. Push the tool over
the terminal and pull the terminal out of the back end of the connector (Figure E–4, View B).
3. If terminal is to be replaced, cut terminal between core and insulation crimp (this minimizes
wire loss).
NOTE: Two special tools are available for this operation: tool J 38125-6 (Paragraph C); tool J 35606 or
J 38852 (Paragraph D).
Crimping Tool
Wire Crimp
Insulation Crimp
Alternate Crimping Tool
Remover Tool
J 38125-6
Anvil “2”
Anvil “5”
J 35606 or J 38852
J 38125-10
Use Description P/N
Throttle Position Connector 12015793
Sensor (TPS) Terminal 12089040
Wire Seal 12015284
RMR Device Connector 12015795
Terminal 12089040
Wire Seal 12015284
Retarder Connector 12015792
Temperature Terminal 12089040
Sensor Wire Seal 12015284
6-Way Gillig VIM (Towers) 6-Way Plug
Connector Seal
Terminal (Socket)
Wire Seal
Cavity Plug
12015799
12010227
12089188
12015323
12010300
6-Way Gillig VIM (Shrouds) 6-Way Receptacle
Terminal (Pin)
Wire Seal
Cavity Plug
12010975
12089188
12015323
12010300