Copyright © 1998 General Motors Corp. E–35
WTEC II ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL
APPENDIX E — CONNECTOR PART NUMBERS, TERMINAL PART
NUMBERS, TOOL PART NUMBERS, AND REPAIR INSTRUCTIONS
1–9. ITT CANNON CONNECTORS — CRIMPED (37-WAY FMTV BULKHEAD;
6-WAY TRANSFER CASE; 8-WAY MD RETARDER)
A. Connector/Terminal Repair
B. Terminal Removal (refer to Figure E–10, Views A and B)
1. Select the remover tool for the plug or receptacle that is being repaired.
2. For the FMTV connector, choose either the pin or socket terminal remover tip and lock it into the
handle.
3. Place the tip of the remover tool over the pin or into the socket and push the contact/terminal out
the rear of the connector using slow, even pressure.
4. Pull the wire and terminal out the back of the connector.
5. If replacing the terminal, cut the wire through the middle of the terminal crimp to minimize wire
loss.
Crimping Tool
Connector Repair Kit (FMTV)
Guide Pin
Insertion Tool
Terminal Remover
Terminal Remover/Installer
(MD Retarder)
Terminal Remover/Installer
(MD 3070 T-Case Connector)
J 34182
J 41193
J 41193-1
J 41193-2
J 41193-3
J 39841
J 39842
Use Description P/N
MD FMTV 37-Way Plug Assembly
37-Way Receptacle Assembly
29502375
29502374
MD Transfer Case 6-Way Plug Assembly
Terminal (Socket)
Cavity Plug
29506418
29517128
29517132
6-Way Receptacle Assembly
Terminal (Pin)
Cavity Plug
29517129
29517132
MD Retarder 8-Way Plug
Terminal, Socket
Cavity Plug
29506427
29517130
29517133
8-Way Receptacle
Terminal, Pin
Cavity Plug
29505513
29517131
29517133
To Next Page
Loading...