Alphasmart NEO 1 - Alphaword Plus Settings

NEO SETTINGS
Changing Settings in the Control Panel
67
. . . . .
NEO 1 and NEO 2
User Manual
AlphaWord Plus Settings
AlphaWord Plus also has its own settings in the NEO Control Panel:
Setting Name What It Does Other Ways to Change This
Turn show marks
in files ON/OFF
When you turn show marks on, in
AlphaWord Plus you will see for
each carriage return (enter), and
you’ll see for each tab that you
type in your file. If show marks is
off, carriage returns are not shown
(except as line breaks), and tabs are
shown as spaces. To change the
setting, move the cursor next to it
and press enter to change it from
on to off or from off to on.
• Press option-a-K in
AlphaWord Plus. In the screen
that appears, press 3 to change
the show marks setting. Then,
press esc.
• In AlphaSmart Manager, click
the Settings tab, select
AlphaWord Plus on the left,
check the Show Marks box, and
click On or Off. Then, send the
changes to NEOs from the Send
List tab.
Turn file
passwords
ON/OFF
This setting is normally off, so
passwords aren’t required to open
AlphaWord Plus files. If you turn
this setting on, you must enter the
file’s password or the master
password when you open a file by
pressing the file key or selecting a
named file. When you first turn this
setting on, the password for all files
is write. Use the next setting to set
individual file passwords.
• Press ctrl-option-a-P in
AlphaWord Plus; then, enter the
master password to change the
setting. Press esc to go back to
AlphaWord Plus.
• In AlphaSmart Manager, click
the Settings tab, select
AlphaWord Plus on the left,
check the Passwords Enabled
box, and click On or Off. Then,
send the changes to NEOs from
the Send List tab.
Change a specific
file password
When file passwords are on or
enabled as described above, you
can use this setting to change the
password for each file. When you
select this setting and press enter,
you’ll see a list of files 1–8 plus any
named files you have on the NEO.
Move the cursor next to a file, press
enter, and enter the current
password once and the new
password twice; then, press enter.
• Press option-a-P in the file that
needs its password changed.
Enter the current password, and
then enter the new password
twice.