NEO SETTINGS
Changing the Transfer Speed for Sending or Beaming Files
73
. . . . .
NEO 1 and NEO 2
User Manual
Wireless Security (NEO 2 Only)
Use this setting to enter the encryption key if it is required for NEO 2 to
communicate with Renaissance Receivers. For more information, contact
Renaissance Learning.
About the Auto Repeat Setting
The Auto Repeat setting is not in the Control Panel, but it is related to the
keyboard settings in the Control Panel.
Normally, when you are typing in AlphaWord Plus, any key that you hold
down will be repeated. If you want to turn this off, follow these steps:
1. Press option-a-K while working on the NEO.
2. Press 1 to turn auto repeat on or off.
3. Press esc to exit the screen and return to your work.
You can also change this setting in AlphaSmart Manager. Simply click the
Settings tab, click System on the left, check the Auto Repeat box, and
click On or Off. Send your settings to NEOs from the Send List tab.
Changing the Transfer Speed for Sending or Beaming
Files
NEO can send text faster than some older computers can accept it. If you
notice missing characters or jumbled text, you may need to slow down the
transfer speed. Even on newer, faster computers, some programs are slow to
accept text, and you must slow down your NEO transfer speed to transfer text
into these programs. You can change the transfer speed for both USB cable
and IR transfers.
You cannot change the transfer speed in the Control Panel, but you can
change it by following the instructions on the next page. Note that the steps
for changing the transfer speed for a USB cable connection are different from
the steps for changing the beaming transfer speed.
To Next Page
Loading...
