Amada HF-2500A - Page 143

APPENDIX E. COMMUNICATIONS
HF-2500A HIGH FREQUENCY WELD CONTROL
990-371 E-21
Command
RELAY <crlf>
ACTIVE1
{ HIGH | LOW }<crlf>
CONDITION1
{condition_value}<crlf>
SUBCOND1
{extended_condition_value}<crlf>
ACT
IVE2 { HIGH | LOW }<crlf>
CONDITION2
{condition_value}<crlf>
SUBCOND2
{extended_condition_value}<crlf>
ACTIVE3
{ HIGH | LOW }<crlf>
CONDITION3
{condition_value}<crlf>
SUBCOND3
{extended_condition_value}<crlf>
ACTIVE4
{ HIGH | LOW }<crlf>
CONDITION4
{condition_value}<crlf>
SUBCOND4
{extended_condition_value}<crlf>
<
lf>
condition_value:
{ ALARM | LIMITS | WELD | END | P1HI | P1LOW | P2HI
| P2LOW}
extended_condition_value:
{ P1HI | P1LOW | P2HI | P2LOW}
NOTES:
P1HI, P1LOW:
Pulse 1 low/hi limit reached.
P2HI, P2LOW: Pulse 2 low/hi limit reached.
Control State
Any
Description
Reports the relay settings.
Command
SECURITY<crlf>
SCHEDULE
{ ON | OFF }<crlf>
SYSTEM
{ ON | OFF }<crlf>
CALIBRATION { ON | OFF }<crlf><lf>
Control State
Any
Description
Returns the current status of the security settings.