HF-2500A HIGH FREQUENCY WELD CONTROL
990-371 ix
SAFETY NOTES
• Lethal voltages exist within this unit. Do not perform any maintenance inside this
unit.
• Never perform any welding operation without wearing protective safety glasses.
This instruction manual describes how to operate, maintain and service the HF-2500A Power Supply, and
provides instructions relating to its safe use. A separate manual provides similar information for the weld
head used in conjunction with the power supply. Procedures described in these manuals must be
performed, as detailed, by qualified and trained personnel.
For safety, and to effectively take advantage of the full capabilities of the weld head and power supply,
please read these instruction manuals before attempting to use them.
Procedures other than those described in these manuals or not performed as prescribed in them, may
expose personnel to electrical, burn, or crushing hazards.
After reading these manuals, retain them for future reference when any questions arise regarding the
proper and safe operation of the power supply.
Please note the following conventions used in this manual:
WARNING: Comments marked this way warn the reader of actions which, if not followed, might result
in immediate death or serious injury.
CAUTION: Comments marked this way warn the reader of actions which, if not followed, might result
in either damage to the equipment, or injury to the individual if subject to long-term exposure to the
indicated hazard.
Disposal
Properly handle and dispose of used materials.
For the disposal of electronic waste please contact AMADA WELD TECH.
To Next Page
Loading...
