MU-100A
12. Timing Chart (2-axis Type)
12-2
*1 When Self Hold Validity is set to Invalid(1), hold the ST-DISP input until the
sequence moves to Weld-Time.
*2 Time from when both LS1 and 2 are input.
*3 The output time of Before/After Weld Time varies depending on settings of Force
Sampling and Force Average.
*4 Set the time longer than the total weld time of welding machine for Weld-Time.
*5 The output time can be selected with Output Select Time.
*6 When NG is output, the sequence ends.
*7 The output time can be selected with Level Select Time.
To Next Page
Loading...
