Chapter 4 — Advanced Operations 127
When the image database is full, and none of the images have
been archived, the unit stops recording. It flashes the Alarms
indicator on the front panel. It also energizes alarm output 16
if the Message Alert option is selected (see Alarm Setup in the
Intellex Installation Instructions). Then it displays the following
screen.
NOTE: This screen only appears when Linear is selected on
the Record Mode screen.
Database Full
Continue at beginning when full. — Select this option to con-
tinue recording images from the beginning of the image data-
base. When the database becomes full, the unit behaves as if
circular mode is selected, recording over the oldest images.
Help — Click to display online help for the screen.
Select one of the following options and click OK:
Continue at beginning. — Select this option to continue re-
cording images from the beginning of the image database.
When the database becomes full, the unit behaves as if circu-
lar mode is selected, recording over the oldest images.
When you select this option, a warning screen appears. If the
database contains unarchived images, refer to Unarchived Im-
ages. Otherwise refer to Archived Images.
To Next Page
Loading...
Need help?
General
