Chapter 2 — Basic Live Operation 11
STARTING
THE INTELLEX UNIT
CAUTION: Before connecting power, set the voltage switch
to the appropriate voltage (“115” or “230”) (see
Intellex Installation Instructions
).
To start up the Intellex unit, simply plug it in. If the unit does
not power up, insert a paper clip into the pinhole below the
power indicator to turn on unit power.
CAUTION: Do NOT modify any BIOS or system settings.
Do NOT reconfigure any hard drives. Otherwise you
will affect unit operation.
During the power-up cycle, the Intellex splash screen appears.
Do not press any buttons on the front panel or any keys on the
keyboard until this screen disappears. Otherwise, you may
interrupt the startup process and affect unit operation. If the
splash screen does not disappear after one minute, see the
Intellex Troubleshooting Guide.
If you are powering up the unit for the first time, a message
may appear with the splash screen. Wait at least two minutes
for both the message and the splash screen to disappear be-
fore referring to the Intellex Troubleshooting Guide.
When the main screen appears, the unit begins showing live
video from the attached cameras, based on the schedule.
CAUTION: Do NOT install any other software, including
screen savers, or you will affect unit operation.
The unit also displays the Enter PIN Code screen if security is
enabled (see Logging In and Changing Users).
To Next Page
Loading...
Need help?
General
