58 Intellex
®
Operating Instructions
Use the Light Change screen to configure the target area for
the light change filter. Once configured, the filter selects video
segments with light level changes. The light level can change
when someone turns lights on or off, uses a flashlight or blocks
the camera lens.
After you select the Light Change filter and click the Setup
button, the Light Change screen appears.
Search Filter Configuration
NOTE: Before following any procedures in this section, select
the search filter and click Setup (see
Filters Search
).
After you select a search filter, use the appropriate filter con-
figuration screen to configure it. This section describes how to
configure each search filter.
• Light Change
• Motion Detection
• Perimeter Violation
Light Change
Light Change: (camera name) — Indicates the camera name.
Image Area — This area of the screen displays a camera im-
age and provides a reference when configuring the filter.
To Next Page
Loading...
