EasyManuals Logo

Ametek 241CE II User Manual

Ametek 241CE II
171 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #126 background imageLoading...
Page #126 background image
PN 903-8797, Rev A
Fault Alarms
Fault alarms indicate that a serious condition has been detected which inter-
feres with proper operation of the analyzer – a failure of an integral part of the
system has occurred. When a Fault alarm is present, the alphanumeric display
will ash and LED 2 turns On to alert the operator that immediate attention is
required (the analyzer requires service).
Because any results obtained under a Fault alarm condition are invalid, the
operation of the analyzer is suspended and the analyzer is placed into Standby
Mode.
O-Spec Alarms
An O-Spec – or out-of-specication – Alarm indicates that the current value
for the O-Spec parameter is higher than a preset value. The O-Spec Alarm
can be enabled from the Stat\History menu.
The O-Spec Alarm currently is used only for HCDP. The HCDP O-Spec Alarm
(HCDPA) indicates that the current HCDP temperature is above (greater than)
the HCDP temperature O-Spec Alarm setpoint value (ApplicCFG : HCDPA).
When the Hydrocarbon Dewpoint O-Spec Alarm (HCDPA) is triggered, LED 6
on the User Interface turns On, but only if the O-Spec Alarm is enabled (Stat\
History : En\Dis Alrm?). If triggered, this alarm will be also be displayed on the
User Interface if the O-Spec Alarm is enabled.
4-38 | 241CE II Hydrocarbon Dewpoint Analyzer

Table of Contents

Other manuals for Ametek 241CE II

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ametek 241CE II and is the answer not in the manual?

Ametek 241CE II Specifications

General IconGeneral
BrandAmetek
Model241CE II
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals