EasyManuals Logo

Ametek 241CE II User Manual

Ametek 241CE II
171 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #161 background imageLoading...
Page #161 background image
PN 903-8797, Rev A
d. Use the following formulas to calculate a new ExLo and ExHi to com-
pensate for the dierences between the input value and the displayed
value:
A = Range Lo (ExLo range [low output from the external water dewpoint/
water content source])
B = Range Hi (ExHi range [high output from the external water dewpoint/
water content source])
C = Reading Lo (external water dewpoint/water content reading on the
User Interface)
D = Reading Hi (external water dewpoint/water content reading on the
User Interface)
E = New ExLo (newly calculated ExLo reading, from Equation 1).
New ExLo =
CD
ABxAC
A
)(
)()(
Equation 1
New ExHi =
CD
ABxAB
E
+
)(
)()(
Equation 2
e. If the new ExLo and new ExHi values are dierent, enter these values in
to the analyzer.
5. Repeat Steps 4-b and 4-c to ensure the readings on the User Interface
match the input signal.
Appendix A | A-5

Table of Contents

Other manuals for Ametek 241CE II

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ametek 241CE II and is the answer not in the manual?

Ametek 241CE II Specifications

General IconGeneral
BrandAmetek
Model241CE II
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals