Section 4 Unit Operation
4-10
Table 4-7 shows the parameters that can be set using the direct keys and menu screen.
Table 4-7 Direct Keys and Parameters
Direct Key
Measurement mode [Meas Mode]
CW/Burst
Frequency acquisition [Freq]
Level acquisition [Level]
Burst [Burst]
Trigger and gate End [Trig]
Trigger delay [TD]
Gate width [GW]
Level 1
None
Mode [Mode]
Auto/Manual
Measurement result assignment
[Last Measure]
Frequency value input [Set Freq]
Count method [Count]
Fast/Normal
Mode [Mode]
Auto/Manual
Auto setup value assignment
[Last Measure]
Level Up [ ]
Level Down [ ]
Burst measurement mode [Mode]
Freq/Width/Period
Bust measurement polarity [Polarity]
(Pos) / (Neg)
Burst width [Width]
Wide/Narrow
Trigger mode [Mode]
Int/Ext/Line
Trigger polarity [Slope]
(Rise) / (Fall)
Gate End [Gate End]
On/Off
Trigger delay value input
Burst monitor screen
Gate width value input
Burst monitor screen
Level 2
None
None
None
None
None
None
None
To Next Page
Loading...