User Manual
23
Press [<] or [>] key or number key to input port. After set is completed, press [C]
key to enter save interface.
Server IP address
Press [<] or [>] to select[Server IP]option:
Press [OK] key to enter Server IP setting interface.
Press [<] or [>] key or number key to input server IP. After set is completed,
press [C] key to enter save interface.
Press [OK] key to save the modification. Press [C] key to cancel.
Server port
Press [<] or [>] to select [Server port] option:
Press [<] or [>] key or number key to input server port. After set is completed,
press [C] key to enter save interface.
Press [OK] key to save the modification. Press [C] key to cancel.
3.4.1.8 Anti-Back
The anti-back feature is designed to prevent misuse of the access control system. The
anti-back feature is most commonly used at parking gates and employee entrance doors,
where there is both an in reader at the entry gate and an out reader at the exit gate. The
anti-back feature requires that for every use of a card at the in reader, there be a
corresponding use at the out reader before the card can be used at the in reader again.
P7 must work with T5s to realize anti-back function.
Via [<] or [>] select [Anti-Back] option:
To Next Page
Loading...
Need help?
General
