ARAG Skipper LT - Functions List; F1 Mark AB

43
8.3 FunctionsList:PAGE3
8.3.1
F1MarkAB
Stores two points A and B on eld; they are used by Skipper LT to create a line to be used as reference track
(T0, Fig. 129) for spraying job underway.
Mark points A and B as follows:
1 Press
F1: Conrmation prompt is displayed Mark new AB reference?
2 Press OK.
3 Drive along the path you wish to use as a reference for the spraying job. Prompt Mark A? is displayed Press OK.
4 Message Drive! is displayed Continue to drive; once you covered the minimum distance (30 m / 95.5 ft), request Mark B? is displayed Press OK.
The display will show the reference track T0 and all tracks to follow when spraying (Fig. 129).
Fig. 126
Fig. 127
Fig. 128
Fig. 129
Usingthe"MarkAB"function,SkipperLTdeletesthepreviousT0referencetrack(ifany),andpromptsyoutostoretwo
NEWpointsAandBoneld,whichcreateaNEWreferencetrack.
PointsAandBcanonlybemarkedwithvehiclemoving.ItisNOTpossibletorecovertheprevioustrackT0.
WORK FUNCTIONS - PAGE 3