ARAG Skipper LT - 5 Installation; Introduction; System Configuration; General Precautions for Locating the Skipper LT and Cable Runs

6
5 INSTALLATION
5.1 Introduction
Installation of the Skipper LT system does not require specialist knowledge.
We recommend however that this be done by a qualied technician in as much as the installation also requires electrical connections to be made.
ARAGISNOTLIABLEFORANYDAMAGECONSEQUENTONINSTALLATIONBYUNQUALIFIEDPERSONS.
IFCASEOFDAMAGETOTHESYSTEMCAUSEDBYINCORRECTINSTALLATIONORCONNECTIONS,THEWARRANTYISAUTO-
MATICALLYVOIDED.
CAUTION!DONOTCONNECTANYANTENNADIFFERINGFROMTHERECOMMENDEDONE(art.no.520110.600).
ARAGWILLBEHELDHARMLESSFROMANYLIABILITYINCASEOFPRODUCTDAMAGES,FAULTSANDRISKSOFANYKIND
CAUSEDBYTHECONNECTIONOFTHEMODULEWITHNON-ORIGINALANTENNASORANTENNASNOTSUPPLIEDBYARAG.
5.2 Systemconguration
Fig. 2
Legend:
A SKIPPER LT satellite navigator
B GPS antenna
C Battery
D Treatment status signal +12 Vdc
(from main control valve)
5.3 GeneralprecautionsforlocatingtheSkipperLTandcableruns
PositioningtheSkipperLTdeviceinthecab:
-DONOTplacethenavigatorinareassubjecttoexcessivevibrationsandshocksorclosetomovingpartswhichmightcause
damages;
-Mounttheremotecontrolunitinavisibleposition,withoutobstructingtheoperator’sview,andwithineasyreachbyhand;
-Takecaretopositionthedeviceawayfrommovingpartstoavoidaccidentaloperationofitskeys.
Insertingtheconnectors:
-FitsuppliedO-ringsintoconnectorsandthenconnectpayingspecialattentiontothenotch.
Pressgentlyandthentightentheringnut.
WARNING:Tightenconnectorringnutsngertight.Donotuseanytools.
-Donotforceinsertionofconnectorsbypressingexcessivelyorbending:contactscoulddamageandcompromisecorrect
operationofthemonitor.
Securingthecables:
-NotethevariousconnectionsrequiredfortheSkipperLTsystemtooperate,thenecessarylengthofthecables,andensure
thatthereissufficientspaceforthecablerunsandconnectors;
-Routethecablesinsuchawaythattwistingandmachinemovementscannotdamageorbreakthem;
-Routethecablesinsuchawaythattheycannotcomeintocontactwithmovingparts;
-If,duetolimitedspace,thecablinghastorunaroundacorner,makesurethatthe
bendisnottoosharpasthismaycausethecabletobreak.
UseONLYtheaccessoriesindicatedinthecatalogue,havingtechnicalfeaturessuitablefortheusetobemadeofthem.
INSTALLATION